![elvira fidelia tanjung elvira fidelia tanjung](https://www.itenas.ac.id/wp-content/uploads/2021/06/BEASISWA-LPDP-2021-UNTUK-DOSEN-ITENAS-2021-2.png)
When y = 0.05 and x = 0.07 the temperature = 510K, and
![elvira fidelia tanjung elvira fidelia tanjung](https://www.researchgate.net/profile/Elvira-Tanjung-2/publication/305637589/figure/fig2/AS:669508712800269@1536634724249/The-overall-dimensions-of-the-experimental-setup-were-350-mm-x-350-mm-x-60-mm-The-pyrex_Q320.jpg)
Is it correct if I make the equation like this : When y = 0.05 the temperature 510 and when y = 0.25 the temperature 500 Kīut the result : the bubbles raised from the bottom (y=0) not from the heater.
Elvira fidelia tanjung how to#
I got stuck and confused how to interpret those conditions into custom field functions. KOTA TANJUNG PINANG, BUKIT BESTARI, KEPULAUAN RIAU, ID, 29124. In my case, my model has a heater, which is located (x = 0.07 and y = 0.05) into (x = 0.23 and y = 0.05). Bagi kamu yang mendapatkan prestasi tingkat internasional, nasional, atau regional di tahun 2019, silakan klik di sini untuk melaporkan capaianmu. While the temperature 0.1168 m from the outlet is 500 (as the T sat). Berikut adalah daftar mahasiswa UGM yang telah berhasil menorehkan prestasinya selama tahun 2019. I set the custom field functions as written in Horizontal Film Boiling Tutorial (ANSYS FLUENT), they used :įrom that equation, as I understood, defined that when y = 0 the temperature (on the heat/wall) is 510 K. Thank you very much, May GOD reward you more. If you don't mind, please share your experiences and knowledge about this problem. The result that I have is, there are bubbles but not even one from the heater, where I think should be from the heater. I think I need to set another Custom Field Function for the X coordinate, while the heater started at (x,y)= (0.07, 0.05) to (0.23, 0.05), but I have no idea how to set this one. I applied the UDF from the ANSYS tutorial (horizontal film boiling) and changed the latent heat as Water Latent heat.Īnd also I set the Custom Field Functions : I ran the simulation with the Heater Temperature 403K, while the backflow total temperature is Saturation Temperature (373K). I set up the heater's material as copper and the rest as aluminium. I want to make a simulation of Pool Boiling using PCB as a heater. 'Local churches are doing online services through Facebook or webinar. She told VOA Indonesia the government has 'urged all places of worship' to restrict gatherings. She remained there for post-doctoral research. in mechanical engineering at Daegus Kyungpook National University.
![elvira fidelia tanjung elvira fidelia tanjung](https://i.ytimg.com/vi/yZimKn9HVSQ/maxresdefault.jpg)
I'm newbie in ANSYS Fluent (CFD simulation). Elvira Fidelia Tanjung is an Indonesian who earned her Ph.D.